THE ARMY PAINTER - TAP GM1002 GAMEMASTER: HOT WIRE FOAM CUTTER

The Army Painter TAP GM1002 GAMEMASTER: HOT WIRE FOAM CUTTER

This incredibly precise Hot Wire Foam Cutter will give you clean, accurate and fast cuts – every time! It is the perfect tool for cutting XPS foam sheets for any dungeon backdrop, wargaming terrain or landscape scenery. Including 4 extra wires.

Note: Batteries NOT included (2x C-batteries).

- Hold activation button to quickly heat wire to 300°

- Move slow for precise cuts– and protect wire

- Max cut size: 4 cm × 12 cm / 1.5  by 4.7 

• No more messy foam cutting - The Hot Wire Foam Cutter cuts through Polystyrene and XPS foam with accuracy and ease.
• Easy to operate with one hand - Simply press the activation button with your thumb and start cutting your styrofoam board.
• Minimal foam board loss - The 0.19mm thin heated hotwire allows for very fine levels of detail.
• Safety precautions – The hot foam wire cutter can reach 300℃/572℉, allowing it to easily cut.

How to use:

• Hold activation button to quickly heat wire to 300°
• Move slow for precise cuts – and protect wire
• Max cut size: 4 cm × 12 cm / 1.5 " by 4.7 "
• Use in a well-ventilated area

Changing wires

The set includes 4 extra wires, to change out the wire:

1. Take out the batteries
2. Take out all old wire parts
3. Put in the tip of the new wire and twist together the end to hold it
4. repeat on both ends
5. Put in the batteries and you are ready to go